Hello friends today I will show how create a 3d electronic meter tutorial
I have used following techniques shown below in this 3ds max tutorial.
[1]-First of all you will press (ctrl +N) now you will see the new window is open
Click on the rectangle button and create a rectangle with the following size
[2]-Apply the Extrude Modifier with the (Amount: 17.5)
[3]-Select the Rectangle and convert into the Editable poly
Select the Edge mode
[4]-Select the Edges and apply the Extrude Edges
Now use the following setting
[5]-Again select the Edges and apply the Chamfer Edges
Now use the following setting
[6]-Create a cylinder and NGon with the following size
Apply the Extrude Modifier on the NGon
Now set like this
[7]-Create a cylinder and set like this
[8]-Create a circle and use the following setting
Now set the Circle like this
Again use the above following step and create a following button like this
